Line 6
DeluxeRvbSNP
Helix LT
This is my normal gigging preset (1 of 4) for live shows. It uses "Stomp/Snap" mode (4 stomps on the top row / 4 Snapshots on the bottom row), and has a CLEAN; a EDGE OF BREAKUP; a CRUNCH/DRIVE; and a DISTORTION on the snapshot rows - Right to left. These are achieved with various amp parameters adjusted for the "just right for the song" settings. The stomps are just 4 effects I use in various songs, Phaser, Flanger, Auto Swell, Chorus, in this case. I also have a Wah assigned to EXP1, and Volume block assigned to EXP2. EXP2 also activates, 1d-midf-boost via an EQ, switches Delays from short to longer/heavier mix/more feedback once you pass 85% of the throw. The volume is also set for 72% at "HEEL DOWN" and 100% at "TOE DOWN", so you can leave it heel-down and have a rhythm volume level, and go to toe-down and have 100% level with all the delay, mid-boost, etc goodness.. once your solo is over, no more "hunting" for the right rhythm level, just go back to toe-down and you're there! The Cab is a stock dual cab, but you could easily insert your favorite IR here. For best results, if you wish to follow my settings, I have Guitar PAD = OFF; 1/4" Input set to: INSTRUMENT level; XLR Out set to "Mic" Level; and I have a -2.0 dB setting on the output block, to keep levels equitable with a mic'd up cabinet, so you're not too hot for the PA. Lastly, I also have a path split-off from the lower signal chain that is set to go to the 1/4" outputs, AND "HELIX VOLUME CONTROL" set to XLR only. This way, what goes to Front of House (PA) via the XLR can not be affected by adjusting the Helix Volume knob. The helix Volume controls only the 1/4" out, and that is the output of the
by GenoBluzGtr · Indexed at CustomTone · 159 source downloads